25.Reinstall the hanger ball on the downrod as follows. Route the motor leads through the hanger ball and slide the hanger ball over the downrod (Figure 11). Install the pin through the holes at the top of the downrod and slide the hanger ball up the downrod, aligning the ball so the pin is captured in the groove in the top of the hanger ball. Pull the hanger ball up tight against the pin and securely tighten the setscrew in the hanger ball. A loose setscrew could create fan wobble.
26.The blue, black, white, and yellow leads exiting the downrod are
WARNING
It is critical that the pin in the hanger ball is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed could result in the fan falling.
|
| CEILING |
|
| COVER |
PIN |
| SCREW |
HANGER |
|
|
BALL |
|
|
DOWNROD | SETSCREW | DECORATIVE |
|
| UPPER SCROLL |
DOWNROD
Figure 11
27.You have now completed the initial assembly of your new ceiling fan. You can now proceed with hanging and wiring your fan.
How to Hang
Your Ceiling Fan
WARNING
The fan must be hung with at least 7' of clearance from floor to blades (Figure 12). Do NOT hang this fan on an 8’ ceiling when using the 12” downrod.
CEILING
WARNING
The outlet box and joist must be securely mounted and capable of supporting at least 50 lbs. Use only a U.L. outlet box listed as “Acceptable for Fan Support of 50 lbs. or Less”.
1.Securely attach the hanger bracket to the outlet box using the two screws supplied with the outlet box (Figure 13).
WARNING
To reduce the risk of fire, electric shock, or personal injury, mount fan to outlet box marked “Acceptable for Fan Support of 50 lbs. or Less”, and use screws supplied with outlet box. Most outlet boxes commonly used for support of light fixtures are not acceptable for fan support and may need to be replaced. Consult a qualified electrician if in doubt.
WARNING
Hanger bracket must seat firmly against outlet box. If the outlet box is recessed, remove wall board until bracket contacts box. If bracket and/or outlet box are not securely attached, the fan could wobble or fall.
| OUTLET |
| BOX |
TWO SCREWS |
|
SUPPLIED WITH | HANGER |
OUTLET BOX | |
| BRACKET |
Figure 13 | TAB |
2.Carefully lift the fan and seat the hanger ball/downrod assembly on the hanger bracket that was just attached to the outlet box (Figure 14). Be sure the groove in the ball is lined up with tab on the hanger bracket (Figure 13).
WARNING
Failure to seat tab in groove could cause damage to electrical wires and possible shock or fire hazard.
OUTLET
BOX
NOTE: CEILING COVER, SUPPLY WIRES
AND FAN WIRES OMITTED FOR CLARITY.
HANGER
BRACKET
Figure 14 | HANGER BALL/ | |
DOWNROD ASSEMBLY | ||
|
AT LEAST
7'
Figure 12 | 7 |
| FLOOR |
WARNING
To avoid possible fire or shock, do not pinch wires between the hanger ball/downrod assembly and the hanger bracket.
U.L. Model No.: CF820
