Emerson EWC09D5 B, EWC09D5 Preparation for USE, ANTENNA/CABLE Connection, Indoor Antenna

PREPARATION FOR USE

ANTENNA/CABLE CONNECTION

Cables used here are commercially available.

[ANTENNA CONNECTION] [CATV/SATELLITE CONNECTION]

VHF/UHF

VHF

UHF

VHF

or

UHF

75-ohm Coaxial Cable

OR

VHF/UHF

Combiner

Adaptor

Flat twin- lead cable

CATV Box or

Satellite Box *

OUT IN

From Cable System or

Satellite Antenna

ANT.	75-ohm
OR	Coaxial Cable

From Cable System

[Fig. 4]

*Some cable TV systems use scrambled signals and require a special converter to receive these channels. Consult your local cable company.

Note to CATV system installer:

This reminder is provided to call the CATV system installer’s attention to Article 820-40 of the NEC that provides guidelines for proper grounding and in particular, specifies that the cable ground shall be connected to the grounding system of the building as close to the point of cable entry as practical.

NOTE:	Bent pin
• Before plugging the an antenna into the ANT. jack of the unit, check that the	Cable
pin is not bent. If it is bent, straighten the pin as illustrated, then plug the pin
into the ANT. jack of the unit.	Plug
	(Needs to be straightened)(Straight pin)

VHF/UHF COMBINED ANTENNA

A VHF UHF 75 ohm combination antenna can be connected to ANT. jack of the unit.

CABLE WITHOUT CONVERTER/ DESCRAMBLER BOX

Use this connection if your cable system connects directly to the unit without a converter box.

VHF/UHF SEPARATE ANTENNAS	CABLE WITH CONVERTER/DESCRAM-
In some areas it will be necessary to use an outdoor	BLER BOX OR SATELLITE BOX
	If your cable service supplies you with a converter
antenna.
	box or if you use a satellite system, you can use the
	basic connection shown above.
	Channel selection must be made with the converter
	box or satellite box. This means that channels cannot
	be changed using the remote control of this unit.

NOTE:

•For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT. jack before moving the unit.

INDOOR ANTENNA

The Indoor Antenna (supplied) is detachable. Insert the stem of the antenna into the hole on the upper-back portion of the unit. Connect the Indoor Antenna to the unit as shown in the diagram. For the best reception, fully extend the Indoor Antenna and make the necessary adjustments. (Avoid touching the top section when adjust- ing.)

NOTE:

•The connection of an Indoor antenna may not always give acceptable TV reception.

–10 –

Indoor Antenna (Supplied)

Flat twin-lead cable

Matching Adapter (Supplied)

ANT. [Fig. 5]

EN