Emerson EWC09D5 B, EWC09D5 owner manual Connecting to External Input Jacks, Mobile Connection

CONNECTING TO EXTERNAL INPUT JACKS

When you watch a program recorded on another source (VCR or video camera), use the	AUX
AUDIO/VIDEO input jacks on the front of the unit.

Connect the AUDIO/VIDEO output jacks of another source to the AUDIO L/R and VIDEO jacks of this unit.

Then hit [SELECT] until “AUX” appears on the screen.

ex.

VCR or video camera, etc.

NOTE:

To the Audio output jacks

(OUT)	Audio Cable	(IN)
	(commercially available)
		VIDEO L AUDIO R
To the Video output jack		[Fig. 6]
(OUT)	Video Cable	(IN)
	(commercially available)

•When you connect a monaural VCR (another source) to this unit, connect the Audio output jack of the monaural VCR (another source) to the AUDIO L jack of this unit. The audio will output in both L and R channel equally.

MOBILE CONNECTION

WARNING: The driver should never watch the unit while operating a motor vehicle.

CAUTION:

•When used in moving vehicle, be sure that the unit is secure at all the times to prevent injury. Consult a professional installer.

•If you use the unit with the vehicle’s engine off, recharge the vehicle’s battery after about every 4 hours of use to prevent it from running down. After you finish using the unit be sure you unplug the car-battery cord from the cigarette-lighter socket.

•Do not use this unit while driving.

•Do not leave this unit in a car.

•This unit is not designed for use in a car.

To the vehicle's	1) The supplied indoor antenna is adequate when your
	vehicle is stationary. For best reception on the road,
cigarette-lighter socket
	use a high-quality VHF/UHF mobile TV antenna.
VHF/UHF Combination	2) Attach the car battery cord to the DC13.2V(12V)
Mobile Antenna	connector on the back of the unit. Then, connect the
(Not supplied)	other end to your vehicle’s cigarette-lighter socket.
	NOTES:
Car battery cord	• Be sure your vehicle has a 13.2-volt (12-volt), nega-
(Supplied)	tive-ground electrical system.
	• Be sure you use only the supplied car battery cord.
ANT.	Using another cord could damage the unit.
DC13.2V	• Be sure the socket is free of ashes and other debris.
	• Be sure to push the car battery cord’s plug completely
	into the cigarette-lighter socket.

•Always unplug the car battery from the cigarette- lighter socket before you unplug it from the unit.

•You must disconnect the car battery cord from the unit before you can use the AC power.

•Be sure to replace the fuse with only the same type, 6A, 250V.

– 11 – EN