Emerson GXT2U user manual Rack-Mount UPS Conversion and Installation, Optional rack mount handles

Rack-Mount UPS Conversion and Installation

NOTE

When rack mounted, the UPS must be supported by a shelf, brackets or slide rails on each side. The rack mount handles WILL NOT support the weight of the UPS. They are used to move the UPS into and out of the rack.

1.For slide rail installations, first remove the top/side fin. Slide the

top/side fin forward, then lift it up to remove. If desired, install the optional rack mount handles that were shipped with the UPS.

UPStation GXT
– +
AC INPUT	BATTERY UPS ON
		BYPASS

Optional rack mount handles

Securing hardware and slide rails are sold separately. Contact your local dealer or Liebert representative for these additional options and any assis- tance needed.

2.Unpack the two (2) rack-mount- ing bracket assemblies and mounting hardware from the rack-mounting kit

(P/N: RMKIT18-32). Bracket assemblies are interchangeable between left-hand or right-hand. Remove inner member of each bracket assembly as shown at right by extending it to its outer- most position, depressing the retaining latch and then pulling inner member from bracket assembly.

Retaining latches

Inner members

Return flanges

Rear members

Front members

3.Determine the height position

inside the rack enclosure where you want to mount the UPS or battery cab- inet.

! CAUTION

Reduce risk of tipping the rack enclosure by placing UPS or battery cabinet in the lowest possible rack position.

9