Install rear member of each | M5 screws |
bracket assembly into rack enclo- | Front rack |
sure with two (2) M5 screws pro- | mounting rails |
vided in this kit. (See figure at |
|
right.) Return flanges on bracket |
|
assembly fit to the inside of rack |
|
mounting rails. Insert screws |
|
loosely |
|
bottom holes of return flange on |
|
rear member. Extend bracket |
|
assembly by sliding front mem- | Rear rack |
ber forward until it touches the | |
front rack mounting rail. Insert | mounting |
two (2) M5 screws loosely (finger- | rails |
tight) into top and bottom holes | M5 screws |
of return flange on each front member. Make sure bracket assemblies are at the same mounting height on all four (4) rack mounting rails.
4.Locate eight (8) M4 screws and eight (8) M4 nuts from hardware pack in this kit. Each nut has a locking, nylon insert that begins gripping the screw when it is halfway tight. Make sure to tighten nut and screw completely to assure locking action. Fasten rear member and front member together using four (4) screws and four (4) nuts per bracket assembly as shown in the figures at right. For maximum support, locate fasteners for each bracket assembly as far apart as possible, depending on rack depth, while still joining both members (See figures at right). Check align- ment of bracket assemblies and
TIGHTEN ALL SCREWS FROM STEPS 3 and 4.
5.Prepare the UPS or battery cabi- net (the “equipment”) for rack mounting by following instructions in the equipment’s user manual. The equipment may require addi- tional parts to be added or parts to be removed for rack mounting. After it is prepared, lay equipment in
M4 nuts | M4 |
| screws |
18" rack |
|
depth | M4 nuts |
| |
M4 nuts | M4 |
| |
| screws |
32" rack depth
| M4 nuts |
M4 screws | Retaining |
| latch |
UPS or battery cabinet
Front
M4 screws
10
