Operating Your Ceiling Fan, Waycontrol

BP7308 LORRAINE KF240 2/15/06 3:21 PM Page 15

9.	Place the second wall control into the	3.	To turn your fan off, press the OFF
	wall box. Screw in place and install		button.
	decorator style faceplate (included).	4.	To set the level of light brightness,
	Leave switch in “OFF” mode until fan		press and hold the LIGHT button. The
	installation is completed.		light brightness will continue to
10.	Refer to page 5 and complete the		increase then decrease while the
	ceiling fan installation .		button is held down. When the light is
			at the desired brightness, release the
STANDARD WIRING FOR EXISTING			button.
3-WAY CONTROL		5.	To turn the light on and off, press and
	EXISTING		release the LIGHT button. The light will
	WALL CONTROL		turn on at the light level previously set
HOT BLK

(see step 4).

TRAVELER WIRES

BLK	BLK
HOT BLK
EMERSON	EMERSON
FAN/LIGHT
WALL CONTROL	TRAVELER WIRES
	TRAVELER WIRES

BLACK

LOAD

BLK

BLACK

LOAD

6. If airflow is desired in the opposite direction, turn the fan off and wait for the blades to stop turning. Remove the lower glass (Figure 17), then slide the reversing switch (located on the light fitter) to the opposite position and turn the fan on again. The blades will turn in the opposite direction and reverse the airflow.

Figure 22

Operating Your

Ceiling Fan

IMPORTANT

Fan installation must be completed, including the installation of the fan blades, before testing of the remote control.

Your Fan/Light Wall Control (Figure 23) has full control of your fan and light. However, airflow direction is controlled by a slide switch on the light fitter.

1. Restore electrical power to the outlet box by turning the electricity on at the service panel.