BP7308 LORRAINE KF240 2/15/06 3:21 PM Page 8
12. Unscrew the two upper setscrews 
(Figure 8) until they clear the inside of the motor coupling. Then separate, untwist and unkink the three 80” motor leads. Route the motor lead wires through the downrod. Align the clevis pin holes in the downrod with the holes in the motor coupling. Install the clevis pin and secure with the hairpin clip (Figure 8). The clevis pin must go through the holes in the motor coupling and the holes in the downrod. Be sure to push the straight leg of the hairpin clip through the hole near the end of the clevis pin until the curved portion of the hairpin clip snaps around the clevis pin. The hairpin clip must be properly installed to prevent the clevis pin from working loose. Pull up on the downrod to make sure the clevis pin is properly installed.
13.Tighten the two upper setscrews (Figure 8) securely while pulling up on the downrod.
NOTE: The setscrews must be properly installed as described above, or fan wobble could result.
14.Position the three scrolls on the decorative coupling cover so that they are vertical, then tighten the nuts on the inside of the coupling cover. Make sure the grommet is properly installed in the decorative coupling cover, then slide the coupling cover over the downrod until it rests on the motor housing (Figure 9).
NOTE: If you installed the 8” downrod, the decorative downrod scroll will not be installed. Disregard step 15 and proceed to step 16.
!WARNING
It is critical that the clevis pin in the motor coupling is properly installed and the setscrew securely tightened. Failure to verify that the pin and setscrew are properly installed (as shown in Figure 8) could result in the fan falling.
DOWNROD
HAIRPIN
CLIP
MOTOR
COUPLING CLEVIS PIN
DECORATIVE
DOWNROD
SCROLL
SETSCREW
COLLAR
SCROLL (3)
MOTOR 
DECORATIVE
HOUSINGCOUPLING COVER 
SETSCREW (2)
Figure 9
| 15. Using the hex wrench (supplied), |
| unscrew the setscrew in the |
| decorative downrod scroll collar until |
| it clears the inside of the collar. Slide |
| the collar over the downrod (Figure |
Figure 8 | 9), until it rests on the coupling cover, |
then tighten the setscrew. |
8
