BP7308 LORRAINE KF240 2/15/06 3:21 PM Page 13
CANDELABRA BULBS (3)
THREADED
NIPPLE
REVERSING
SWITCH
LIGHT
FITTER
ANTENNA WIRE
ON
RECEIVER | CODE | WALL CONTROL | ||||
SWITCH | LEVERS |
|
| |||
4 | 3 | 2 | 1 | |||
|
| |||||
RECEIVER |
|
|
|
| ON | |
|
|
|
|
| ||
SWITCH LEVERS |
|
|
|
|
| |
1 | 2 | 3 | 4 | CODE |
ON |
|
|
| SWITCH |
|
|
|
| |
WALL |
|
|
|
|
CONTROL |
|
|
| |
LOWER | RUBBER |
GLASS | WASHER |
METAL
WASHER
Figure 17
1/8 x 24 NUT
DECORATIVE CAP
FINIAL NUT
Figure 18
Installation of Wall
Control
Setting Operating
Frequency of Wall
Control and Receiver
(Figure 18)
Your wall control and receiver have code switches which must be set in one of 16 possible code combinations. The four levers (numbered 1, 2, 3, and 4) on the switches are
1. Slide the four switch levers in the wall control to your choice of ON (up) or down positions. Use a 
small screwdriver and slide the levers firmly up or down.
2. In the receiver, slide the four switch levers to the same positions as set in the wall control. Make sure the levers on both switches are in the same positions, otherwise the fan will not operate.
(Figure 19)
HOT | BLK | FAN/LIGHT |
|
WALL CONTROL |
| ||
| EMERSON | BLACK |
|
|
| BLACK | LOAD |
NEUTRAL |
|
| GROUND |
|
|
| |
REMOTE CONTROL |
|
| |
RECEIVER LOCATED |
|
| |
WITHIN THE CEILING |
|
| |
COVER |
|
|
|
Figure 19
1. Disconnect power at circuit breaker or remove fuse.
2. Remove faceplate and screws from existing wall control. Pull control out from the wall box. Determine the “hot” wire and the “load” wire and disconnect these wires from control. Do not attempt to disconnect any wires not already connected to existing control.
3. Before installing wall control, place wall control in “OFF” mode by pushing “ON/OFF” switch to the “OFF” position.
13
