4)Invert signal:

·You can decide, if the measurement signal should be inverted at the relay output. This can be necessary to combine a failure with an alarm control.

„Press the 8 -key or the → -key in the line "Invert signal" to select the parameter and adjust "Enabled" or "Disabled" with the − -key or the ↓ -key.

„Confirm the parameter selected with the 8 -key or the → -key.

The last three lines of variables in the menu "Relay Outputs" only display some adjustments of the relay output selected! They are not available:

¨"Signal comes from:" displays the source module selected for the current relay output.

¨"Signal name:" displays the signal selected for the current relay output.

¨"Actual state:" displays if the relay status of the current relay is "On" or "Off".

5 - 92

NGA 2000

90003482(2) [NGA-e (MLT-Software 3.2.X)] 07/98