Emerson manual SS-100 to Reflecs Steps, Wiring Layout with UltraSite

Models: SS-100

1 15

Page 9

7.Plug 110VAC/5VDC power transformer into the SS-100.

1.Connect the 25-pin end of the D25/DB9 straight- through connector to the SS-100.

2.Connect the 9-pin female end of the laptop cable to the straight-through serial connector.

3.Connect the SS-100 to the hub using the RJ-45 able.

4.Plug the 4-position plugable connector into the Reflecs controller.

5.Plug 110VAC/5VDC power transformer into the SS-100.

SS-100 Serial Server

SS-100 Wiring Requirements • 3

Image 9

Contents

SS-100 Serial Server Installation and Programming Guide 026-1607 Rev 4 07-APR-2010Page Phone Page 3.3.1. UltraSite 4.1.1. Troubleshooting3.3.2. HALComm Table of ContentsPage 1.1. Working with the Network Administrator 1 Installing the SS-1001.2. IP Address Specification 1.4. Ethernet Network Wiring and Wire TypesWiring Layout with HALComm 2.1. SS-100 HALComm and UltraSite Wiring LayoutsSS-100 Direct to HALComm Steps Comm controller will eliminate stepsSS-100 to Reflecs Steps Wiring Layout with UltraSiteDevice Configurator Search Tool Outlined 3 Configuring the SS-100in the list Choose and Highlight the Device3.2. Setting the Server Properties 3.1. TCP/IP SetupPassword Screen NOTE The Password screen appears only once per sessionSerial Port Settings Screen for UltraSite Server Settings Outlined in Red3.3.1. UltraSite Go Back Screen3.3.2. HALComm Serial Port Settings Screen for HALCommClick the Update Port Settings button Check the Inactivity Logout and Modem Emulation boxes4.1.1. Troubleshooting 4.1. UltraSite32 Setup as Alarm Re- ceiver for SS-1004 Reflecs 4.2. BCURemote Communication to access the Commu 4.4. RMCC