Emerson UWL owner manual Mounting The Tank, Connecting Faucet To Tank

3

MOUNTING THE TANK

A

Tank must be mounted level to ensure proper operation.

Property Damage: Tank must be located within 16" of faucet and within 30" or less of a standard grounded outlet. DO NOT extend plumbing or electrical lines.

■Select a spot under the sink to mount tank vertically within reach of both plumbing and electrical connections. The tank should be within 16" or less of faucet water lines and within 30" or less of a standard grounded outlet.

■While holding tank in place on

the spot selected for installation, use a pencil to mark locations for 2 hanging screws.

B

Leave 1/4" for hanging tank.

Screws provided are for use in wood studs or cabinets only. Use wall anchors (not supplied) for installation into drywall.

Mount tank vertically in an area that

allows clearance on the underside of the

tank for drainage, if necessary. DO NOT over tighten screws.

■Pre-drill 1/8" pilot holes at marks.

■Turn screws into pre-drilled holes, leaving 1/4" exposed.

■Hang the tank on the screws.

■Tighten the screws with only 1/2 turn clockwise.

4
	CONNECTING FAUCET TO TANK
	A	■ Without depressing the gray button,
		place the snap-connect fitting at
	(1)	(2) (3) the end of the blue 1/4" tube onto
		the left fitting on the tank, pushing
		until it clicks into place. (1)

		■ Slip the flexible white 7/16" tube
		over barbed middle fitting and slide
		down approximately 1/2". (2)
		■ Slip the clear 5/16" tube over the far
		right smooth fitting and slide down
		approximately 1/2". (3)
		■ Visually check for pinched or
Property Damage: Pinched or blocked water lines
		crimped tubes.
may cause damage to the dispenser tank.
Property Damage: Check to make sure		Hose clamps are not needed for any
	tubes are connected properly and are	of the connections.
	pushed down as far as possible.

6