Installation
4.0INSTALLATION
4.1References
This document must be used together with
4.2Installation Considerations
Liebert XDCF modules must be securely mounted to the rear of the Egenera BladeFrame cabinet. No cutting or drilling is required to attach the modules; all mounting holes, slots and pins required are fabricated at the factory.
If only one Liebert XDCF will be attached to an Egenera BladeFrame cabinet, Liebert recommends using the lower Liebert XDCF module. If both an upper and a lower Liebert XDCF module will be attached, attach the lower unit first.
Liebert XDCF modules attach beside the power modules on the rear of the Egenera BladeFrame (see Figure 6).
Figure 6 Liebert XDCF unit mounting locations
7
