Installation

Attaching Liebert XD Flex Pipe Support Panel

Use of only the lower Liebert XDCF module requires attaching a Liebert XD Flex Pipe support panel and three pipe retainers. The retainers keep the refrigerant pipes behind the Egenera cabinet. If an upper Liebert XDCF module will be used, the Liebert XD Flex Pipe retainers will be attached to the upper module.

To attach the Liebert XD Flex Pipe support panel:

1.Position the Liebert XDCF Liebert XD Flex Pipe support panel over the line of four holes above the right edge of the lower Liebert XDCF module

2.Secure the Liebert XD Flex Pipe support panel to the cabinet by inserting and tightening four screws on the panel’s flange. Tighten the fasteners securely with a screwdriver, either a Phillips or a blade-type.

3.Attach the three pipe retainers:

a.Slip the front end of a retainer into a slot on the Liebert XD Flex Pipe support panel.

b.Insert a panel fastener into the retainer and thread it into the captive panel nut.

c.Tighten the fastener securely, using a screwdriver, either a blade-type or Phillips.

d.Repeat Steps a and c for the other retainers.

Figure 9 Liebert XD Flex Pipe support panel attachment

Liebert XD Flex Pipe support panel and retainers

Lower

Captive

Panel

Nut

Liebert XD

Flex Pipe

Support Panel

Captive

Panel

Nuts

Captive Panel

Fastener

Liebert XD

Flex Pipe

Retainers

CF unit

Captive Panel

Fastener

10

Page 14
Image 14
Emerson XDCF user manual Attaching Liebert XD Flex Pipe Support Panel, Liebert XD Flex Pipe support panel attachment