Empire Comfort Systems CIBV-30-20 installation instructions MAINTENANCE continued, Glass Cleaning

MAINTENANCE (continued)

Glass Cleaning

It will be necessary to clean the glass periodically. During start-up condensation, which is normal, forms on the inside of the glass and causes lint, dust and other airborne particles to cling to the glass surface. Also initial paint curing may deposit a slight film on the glass. It is therefore recommended that the glass be cleaned two or three times with a non-abrasive household cleaner and warm water (we recommend gas fireplace glass cleaner). We do not recommend using packaged spray type household glass cleaner. After that the glass should be cleaned two or three times during each heating season depending on the circumstances present.

General Glass Information

Only glass approved for use in Empire Comfort Systems, Inc. fireplaces may be used for replacement. The glass replacement should be done by a licensed or qualified service person.

WARNING:

1.The use of substitute glass will void all product warranties.

2.Care must be taken to avoid breakage of the glass.

3.Under no circumstances should this appliance be operated without the glass front or with a broken glass front. Replacement of the glass (with gasket) as supplied by the manufacturer should be done by a qualified service person.

4.Do not abuse the glass by striking or hitting the glass.

WARNING: Do not use abrasive cleaners on glass. Do not attempt to clean glass when glass is hot.

Failure to follow these warnings could cause a serious safety issue to the operator, such as fire or other serious conditions.

Glass Assembly Replacement

1.Remove casting top from casting.

2.Remove casting front from casting.

3.Lower valve cover on firebox.

4.Release two door latches at bottom of firebox.

5.Grasp bottom of glass frame, lift glass frame upward in order to release glass frame from lip on top of firebox.

6.Place glass frame assembly on a non-abrasive surface. The exterior of the glass frame assembly should be facing the non-abrasive surface.

7.Insert a putty knife between glass and bottom corners on frame. Carefully separate glass from frame.

8.Use putty knife to remove silicone and gasket material from frame. Surface of frame must be clean and dry.

9.At each corner of frame apply (2) three inch beads of high temperate (orange) silicone.

10.With thin gasket on glass facing silicone on frame, insert glass into frame. Carefully press the glass onto frame in order to have contact between glass and silicone.

11.Allow silicone to set-up for an adequate time.

12.Align and place top of glass frame over lip on top of firebox. Grasp bottom of glass frame, push inward and place glass frame onto firebox.

13.Attach two door latches to bottom of firebox.

14.Replace casting front onto casting.

15.Replace casting top onto casting.

16.Replacement of glass assembly is completed.

Figure 22

Page 20 15627-5-0807