VFP(32,36)FP(30,31) LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance areaforgas.Besuretosmellnexttothefloorbecausesome gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electrical switch;
Do not use any phone in your building.
•Immediately call yourgas supplierfrom a neighbor's phone. Follow the gas supplier's instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it; call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
1. | STOP! Read the safety information label. |
| 8. | Turn gas control knob counterclockwise | to "PI- | |
2. | Set REMOTE/OFF/ON switch to "OFF." |
|
| LOT." |
| |
3. | Turn off all electric power to the |
| 9. | Push in control knob all the way and hold in. Repeatedly | ||
| appliance (if applicable). |
|
|
| push the Piezo Ignitor Button until the pilot is lit. Continue | |
4. | Open bottom louver assembly. |
|
| to hold the control knob in for about one (1) minute after | ||
5. | Push in gas control knob slightly and |
|
| the pilot is lit. Release knob, and it will pop back up. Pilot | ||
| turn clockwise | to "OFF." | GAS CONTROL KNOB |
| should remain lit. If it goes out, repeat steps 5 through 9. | |
| NOTE: Knob cannot be turned from | SHOWN IN "OFF" POSITION. | • | If knob does not pop up when released, STOP and IM- | ||
|
| |||||
| "PILOT" to "OFF" unless knob is |
|
| MEDIATELY call a qualified service technician or gas | ||
| pushed in slightly. Do not force. | REMOTE |
| supplier. |
| |
6. | Wait ten (10) minutes to clear out any gas. | OFF | • | If the pilot will not stay lit after several tries, turn the gas | ||
ON | ||||||
| Then smell for gas, including near the floor. If |
|
| control knob to "OFF" and call your service technician or | ||
| you smell gas, STOP! Follow "B" | PILOT |
| gas supplier. |
| |
| in the safety information above. If | THERMOPILE | 10. | Turn gas control knob counterclockwise | to | |
| ELECTRODE | |||||
| you do not smell gas, go to the next |
|
| "ON." |
| |
| step. |
|
| 11. | Close bottom louver assembly. |
|
7. | Find pilot - Follow metal tube |
| 12. | Turn on all electric power to the appliance (if appli- | ||
| from gas control. The pilot is THERMOCOUPLE |
| cable). |
| ||
| behind the burner on the right (LPG) | THERMOCOUPLE | 13. | Set REMOTE/OFF/ON switch to desired setting. |
| |
| side. |
| (NATURAL) |
|
|
|
TO TURN OFF GAS TO APPLIANCE
1.Set REMOTE/OFF/ON switch to "OFF."
2.Turn off all electric power to the appliance if service is to be performed (if applicable).
3.Open bottom louver assembly.
4.Push in gas control knob slightly and turn clockwise to "OFF." Do not force.
5.Close bottom louver assembly.
Page 17 |