BURNER INSTRUCTIONS
Check the following items during installation prior to lighting the multisided burner:
•Check all carryover ports for blockage from the ceramic media
o If there is blockage, use a small pointed tool to move the ceramic media away from the carryover port.
•For best results when lighting the burner, have your adjustable flame knob to the HI position, then adjust to a lower setting after the burner has ignited.
•When first lighting the pilot on the burner, it takes approximately 60 to 75 seconds to fully heat and energize the thermopile. Once the thermopile is energized, turn on the gas valve and light the burner.
•Check air shutter for correct setting.
o NAT gas – Air shutter 1/8" (3.2 mm) minimum open
AIR SHUTTER 1/8” (3.2mm) OPEN
o LP gas – Air shutter full open
AIR SHUTTER
FULL OPEN
Page 21 |
