Introduction

Instructions to Installer

1.Installer must leave instruction manual with owner after installation.

2.Installer must have owner fill out and mail warranty card supplied with unvented room heater.

3.Installer should show owner how to start and operate unvented room heater.

Always consult your local Building Department regarding regulations, codes or ordinances which apply to the installation of an unvented room heater.

This appliance may be installed in an aftermarket* manufactured (mobile) home, where not prohibited by state or local codes.

*Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases.

Warning: Any change to this HEATER or its controls can be dangerous.

Improper installation or use of the heater can cause serious injury or death from fire, burns, explosion or carbon monoxide poisoning.

This series is design certified in accordance withAmerican National Standard Z21.11.2 by the Underweriters Laboratories, Inc. as an Unvented Room Heater and should be installed according to these instructions.

Any alteration of the original design, installed other than as shown in these instructions oruse with a type of gas not shown on the rating plate is the responsibility of the person and company making the change.

750 Millivolt System

When you ignite the pilot, the thermocouple produces millivolts (electrical current) which energizes the magnet in the gas valve. After 30 seconds to 1 minute time period you can release the gas control knob and the pilot will stay ON. Allow your pilot flame to operate an additional one (1) to two (2) minutes before you turn the gas control knob from the PILOT position to the ON position. This time period allows the millivolts (electrical energy) to build-up to a sufficient level allowing the gas control to operate properly.

Important

All correspondence should refer to complete Model Number, Serial Number and type of gas.

Attention: During initial use of ceramic log you will detect an odor as the ceramic log is cured. Also, during the curing process the ceramic log will burn with a yellow flame.

Notice: During initial firing of this unit, its paint will bake out, and smoke will occur. To prevent triggering of smoke alarms, ventilate the room in which the unit is installed.

Installation on Rugs and Tile

If this appliance is installed directly on carpeting, tile or other combustible material other than wood flooring the appliance shall be installed on a metal or wood panel extending the full width and depth of the appliance.

The base referred to above does not mean the fire-proof base as used on wood stoves. The protection is for rugs that are extremely thick and light colored tile.

Solid-fuels shall not be burned in a masonry or UL 127 factory- built fireplace in which an unvented room heater is installed.

Qualified Installing Agency

Installation and replacement of gas piping, gas utilization equipment or accessories and repair and servicing of equipment shall be performed only by a qualified agency. The term "qualified agency" means any individual, firm, corporation or company which either in person or through a representative is engaged in and is responsible for (a) the installation or replacement of gas piping or (b) the connection, installation, repair or servicing of equipment, who is experienced in such work, familiar with all precautions required and has complied with all the requirements of the authority having jurisdiction.

State of Massachusetts: The installation must be made by a licensed plumber or gas fitter in the Commonwealth of Massachusetts.

Sellers of unvented propane or natural gas-fired supplemental room heaters shall provide to each purchaser a copy of 527 CMR 30 upon sale of the unit.

In the Sate of Massachusetts, unvented propane and natural gas-fired space heaters shall be prohibited in bedrooms and bathrooms.

The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, International Fuel Gas Code, ANSI Z223.1.*

*Available from the American National Standards Institute, Inc. 1430 Broadway, New York, N.Y. 10018.

High Altitudes

For altitudes/elevations above 2,000 feet (610m), ratings should be reduced at the rate of 4 percent for each 1,000 feet (305m) above sea level. Contact the manufacturer or your gas company before changing spud/orifice size.

Well Head Gas Installations

Some natural gas utilities use "well head" gas. This may affect the Btu output of the unit. Contact the gas company for the heating value. Contact the manufacturer or your gas company before changing spud/orifice size.

WARNING: This appliance is equipped for (natural gas or propane) gas. Field conversion is not permitted.

Page 6

26670-0-0110

VFP36PP32EP-2, VFP36SP32EP-2, VFP36SP32EN-2, VFP36PP32EN-2 specifications

Empire Comfort Systems offers a range of high-quality vent-free fireplaces, including the models VFP36SP32EN-2, VFP36SP32EP-2, VFP36PP32EP-2, and VFP36PP32EN-2. These models are engineered to provide both warmth and elegance, making them an exceptional choice for enhancing the ambiance of any living space.

One of the key features of these vent-free fireplaces is their impressive heating efficiency. They are designed to provide an optimal heat output without the need for a traditional flue or venting system, allowing homeowners to enjoy a cozy atmosphere without the associated installation and maintenance costs. With their high-efficiency gas burning systems, these fireplaces convert a significant portion of their fuel into heat, resulting in less energy waste and lower utility bills.

The VFP models are equipped with state-of-the-art flame technology, which produces realistic and visually appealing flames that mimic the beauty of a traditional wood-burning fire. The flame appearance can enhance any room’s aesthetics, creating a warm and inviting atmosphere that is perfect for gatherings or quiet evenings at home.

Another notable characteristic is the variety of styles available. The VFP36PP models feature a more modern, contemporary design, while the VFP36SP models have a traditional aesthetic that fits well with classic décor. This versatility in style allows homeowners to select a model that best suits their interior design preferences.

Safety is also a top priority with these fireplaces. They come with built-in safety features, including an automatic shut-off system that activates if the pilot light goes out, ensuring peace of mind for users. The models are also equipped with thermostat controls, allowing for easy temperature adjustments to maintain a comfortable environment.

In terms of fuel options, these vent-free fireplaces can operate on both natural gas and propane, providing flexibility based on the needs and availability of fuel sources. Moreover, they have a compact design, making them an excellent choice for smaller spaces or homes where traditional fireplaces may not be feasible.

In summary, Empire Comfort Systems' VFP36SP32EN-2, VFP36SP32EP-2, VFP36PP32EP-2, and VFP36PP32EN-2 models stand out for their efficiency, aesthetic appeal, safety features, and versatility. These vent-free fireplaces are an exceptional addition to any home, offering warmth and style with the convenience of easy installation and operation.

Empire Comfort Systems VFP36SP32EP-2, VFP36SP32EN-2, VFP36PP32EN-2, VFP36PP32EP-2 Introduction

Models: VFP36PP32EP-2 VFP36SP32EP-2 VFP36SP32EN-2 VFP36PP32EN-2

INTRODUCTION