Empire Comfort Systems VFP36PP32EN-2 installation instructions see-throughfireplace models

INSTALLATION INSTRUCTIONS EMPIRE AND OWNER'S MANUAL

Comfort Systems

Premium Vent-Free

Multi-Sided Fireplaces

see-through fireplace models:

vfp36sp32en-2 vfp36sp32ep-2

peninsula fireplace models:

vfp36pp32en-2 vfp36pp32ep-2

GAS-FIRED

U.L. File: MH46389

ANSI Z21.11.2 Gas Fired Decorative Type Unvented Room

Heaters.

Installer: Leave this manual with the appli- ance.

Consumer:Retain this manual for future refer- ence.

WARNING: If the information in these in- structions are not followed exactly, a fire or ex- plosion may result causing property damage, personal injury or loss of life.

—Do not store or use gasoline or other flamma- ble vapors and liquids in the vicinity of this or any other appliance.

—WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electrical switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas suppli- er’s instructions.

•If you cannot reach your gas supplier, call the fire department.

—Installation and service must be performed by a qualified installer, service agency or the gas supplier.

This appliance may be installed in an aftermarket, permanently located, manufactured (mobile) home, where not prohibited by local codes.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases.

This is an unvented gas-fired heater. It uses air (oxy- gen) from the room in which it is installed. Provisions for adequate combustion and ventilation air must be provided. Refer to page 8.

WARNING: If not installed, operated and maintained in accordance with the manufacturer's instructions, this product could expose you to substances in fuel or from fuel combustion which can cause death or seri- ous illness.

Water Vapor: A By-Product of Unvented Room Heaters

Water vapor is a by-product of gas combustion. An unvented room heater produces approximately one (1) ounce (30ml) of water for every 1,000 BTU's (.3KW's) of gas input per hour. Refer to page 8.

Page 1