Empire Products GWT-35-2(SG Finishing Instructions, Plastering Figure, Installing Furnace Figure

621/4”

(1581 mm)

14 ½”
(368 mm)	66 1/8”
	(1679mm)
	WALL
	OPENING

Figure 2 Figure 3

FINISHING INSTRUCTIONS

Plastering (Figure 4)

In new construction use only plain (not perforated) gypsum lath around furnace and vent pipe so that plaster "Keys" will not project into wall space.

Use wood strips nailed to inside of studs and top of bottom plate. These must be removed before installation of furnace. Lath and plaster against top projection of Header Plate.

Do not allow wall finish materials to project into furnace recess.

Installing Furnace (Figure 5)

Clear the recess of all debris, and remove any wood plaster-grounds. Stand the furnace on floor in front of wall opening.

Insert furnace flue into rectangular opening in header plate and raise furnace carefully (see Figure 5). Swing bottom of furnace into wall opening with back of legs flush with rear of floor plate. Secure furnace support legs to the floor plate.

14½”

(368 mm)

661/8”

(1679mm)

WALL

OPENING

Figure 4 Figure 5

12425-10-1008 Page 9