OWNERS MANUAL | VERITAS™ |
Safety Concerns
IMPORTANT: Please retain the carton and packing materials for this ENERGY® Veritas™ product to protect it in the event you ever need to transport the unit for any reason. Product received damaged at a service center that has been shipped by the end user in other than the original packaging, will be repaired, refurbished and properly packaged for return shipment at the end user's expense.
CARE OF THE FINISH
Your new Veritas™ series speakers should be gently cleaned with only a damp cloth and warm water from time to time to remove any dust or fingerprints. Do not use an abrasive cleaner, or any type of ammonia based cleaners, or window type cleaners. To remove the dust from the grill cloth, use the brush attachment on your vacuum cleaner or a slightly dampened sponge or dust free cloth.
SPIKED AND RUBBER FEET
The Veritas™ V2.1 and V2.2 bookshelf loudspeakers include two rubber feet. These are to be attached to the speaker in the front corners when used with other stands, or if placed on a bookshelf or other stable surface. The bumpers are self adhesive and will protect the speaker as well as the surface it sits on. The rear of the speaker is supported by the single rest in the middle. See Figure 8.
The V2.3 and V2.4 floor standing models however have four metal spikes included, with five insert locations. Use the spikes only on a carpeted surface as they can damage hardwood floors. You have a choice of using three spikes, two in the front, one in the rear, or four spikes, one in each of the speakers' corners. See Figure 9.
NOTE: Use the four spike option if you are concerned about stability.
After installing the spikes and locating the speaker, do not move the speaker by any type of dragging motion. It can not only scratch the floor, but the inserts in the base of the speaker could be damaged. Always completely lift the speaker up to relocate its position.
SPIKE INSTALLATION INSTRUCTIONS
To insert the spikes, place the speaker carefully on its side, and insert the spikes into the desired locations. Then turn the spike by hand to the right until it is firmly seated. The spikes can also be used as levelers in case the floor is not perfectly level. See Figure 9.
12
34
5
FIGURE 9
FIGURE 8
13
