Energy Speaker Systems 7AI manual Connecting the Veritas 2.0R Rear Channel, Surround Speaker

OWNERS MANUAL VERITAS™

2)Next, connect the second cable, from the amplifiers other channel to the lower set of terminals again ensuring a tight connection.

3)Repeat Steps 1 and 2 for the second loudspeaker using the second amplifier. See Figure 5.

NOTE: Notice the upper and lower terminals accept the wire from a different angle, this is to simplify the connection process by making access easier, and to improve cosmetics by allowing easier “dressing” of the cables.

– + – +

FIGURE 5

Connecting the Veritas™

2.0R Rear Channel

Surround Speaker

NOTE: The four connectors on the V2.0R speaker differ slightly from the other models.

PLEASE READ THIS SECTION CAREFULLY.

Under normal circumstances, you will never have the need to bi-wire, or bi-amplify the rear channel speakers in a typical home theater system. If you are unsure, in the meantime you may choose to connect them using the Standard Connection Method described below. Ask your authorized ENERGY® Veritas™ dealer if there are any questions about your systems' particular needs.

CONNECTION OF V2.0R

1.Please ensure the gold straps are in place between the upper and lower terminals before starting. Using your choice of bare wire, banana-type jacks, or spade lugs, connect the speaker cable from the amplifier (minding the positive and negative polarities), to the lower set of connectors. Ensure the terminals are tight.

2.Repeat the procedure for the other rear channel speaker. See Figure 6.

– + – +

FIGURE 6

BI-WIRING AND BI-AMPLIFICATION

If you wish to bi-wire, or bi-amplify the V2.0R Rear Channel speakers, you may do so, however the terminals on the back are slightly different from the terminals found on the other models. The same four connectors are present, the difference being the type of connector, and the shape and type of gold-strap used to connect the upper and lower set of terminals. Refer to the Connection Instructions for Bi-Wiring, and Bi-Amplification for details on how to wire in this manner.

NOTE: To remove the straps from V2.OR, loosen the gold terminals, and pull the strap out to the right. It should easily fall out of place. Make sure you put them in a safe place for future use.

9