EnGenius Technologies DURAFON-1X manual Making a 2-Way/ Intercom Call, Making a Broadcast

Notes:

1.After a link established, the Base ID will appear on the upper- right corner. If no Base ID show up, it applied that you are approaching the boundary of the coverage.

2.If the line is occupied, the LCD shows “No Line Available” and handset returns to standby mode.

3.If a link cannot be established, the LCD will show “No Base” after a 12-second time out.

4.A call duration timer will start displaying the length of the call after link is established.

Making a 2-Way/ Intercom Call

The EnGenius Industrial Cordless Phone System offers private, Intercom/ 2- way radio calls independent of the base station. Intercom/ 2-way communication can be placed from or to base stations and handsets.

A. Handset to Handset Calls
1.	Press Intercom key followed by a two-digit handset	­ 11
	ID or Group ID.	Please enter
		Ext. #: 12
2.	Press END key to end the call.

Notes:

1.Intercom calls can be made regardless if the Base Station is present.

2.If a Group ID is entered, the first handset (belonging to that group) that answers will establish a link with the caller. See Handset Group Subscription.

3.If a link cannot be established, the LCD shows “No Connection” after a 12-second time out.

base by pressing INTERCOM again. However, once a handset answers, only the answering handset can end the call.

C. Intercom/2-Way from Handset to Base
1.	Press Intercom key followed by a two-digit base ID.
		­ 11
	[Note: Base 1 ID as 10, Base 2 ID as 20, Base 3 ID
		Please enter
	as 30, and Base 4 ID as 40]
		Ext. #: 10
2.	The base will ring once, then automatically connect
	the intercom call from a handset.

Making a Broadcast

A. Handset to Handset Calls

1.Broadcasting all handsets

a. Press “BROADCAST” key from one handset.

b.	After hearing bi-bi-beep signal; begin broadcast	­ 11
	message.	PA paging
c.	All related handsets, within communication	to all…
	range of initiating handset, will receive the
	broadcast.

d.Press END key to end the broadcasting.

2.Broadcasting a group of handsets

a.Enter the Group ID and then press

	“BROADCAST” key.	­ 11
b.	After hearing bi-bi-beep signal; begin broadcast	PA paging
	message.	to Ext. # 02
c.	All related handsets, within group and within
	communication range of initiating handset, will
	receive the broadcast.

B. Intercom/2-Way from Base to Handset

1.Press Intercom key on the base station to intercom all registered handsets. The first handset to answer will establish a voice link with the base.

2.The INTERCOM LED will flash until a handset responds.

­ 11

Intercom from Base 1

SLIENT

d. Press END key to end the broadcasting.
3. Broadcasting an individual handset
a. Enter the Handset ID and then press
“BROADCAST” key.	­ 11
b. After hearing bi-bi-beep signal; begin broadcast	PA paging
message.	to Ext. # 12

3.The base unit will page for 15 seconds, then terminate the page if no handset responds.

4.Before a handset answers, the INTERCOM can be cancelled from the

c.	The related handset, within communication
	range of initiating handset, will receive the
	broadcast.
d.	Press END key to end the broadcasting.

~23~ ~24~