![](/images/new-backgrounds/1118173/118173123x1.webp)
The MultiSwitch 700 Device View
Configuring the COM Port
You can use the COM Port Configuration window (Figure
1.Click on Device in the Device View menu bar to display the Device menu.
2.Click on COM Port Configuration and then right to select Port 1. The COM Port Configuration window, Figure
Figure 2-18. The COM Port Configuration Window
You can use the COM Port Configuration window to set the following operating parameters:
COM Port Admin
Use this field to administratively enable or disable the COM port.
COM Port Function
Use this field to select the function for which you wish to use the COM port:
LM | Local Management: select this option if you wish to connect a |
| terminal to the COM port from which to run Local Management. |
UPS | Select this option if you wish to connect an uninterruptable |
| power supply (UPS) to the COM Port. Note that if you select this |
| option, an additional option — UPS — displays on the Device |
| menu when you exit and |
| resulting window to configure specific UPS settings. |
SLIP | Select this option to use the COM port as a SLIP connection for |
| |
| port on your network management workstation. Note that when |
| you configure the port as a SLIP connection, you must select the |
| desired baud rate in the Speed Selection field described below. |
Managing the Module |