Connecting to Console Port for Local Management
Figure 3-10 Connecting an IBM PC or Compatible
Console
| M |
| GR |
| RPS |
C | UP |
PU | DO |
| WN |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Ä Ã |
| Á | À | Â | |||||||||
1 | DB9 female connector | 4 | DB9 female connector |
|
| |||||||||
2 | Serial interface cable | 5 | PC with VT emulation application | |||||||||||
3DB9 male Console port connector
Connecting to a VT Series Terminal
To connect a VT Series terminal to an Enterasys switch Console port (Figure 3‐11), use a UTP serial interface cable terminated with a DB9 female connector and a DB25 female connector and proceed as follows:
1.Connect the DB9 female connector at one end of cable to the Console port DB9 male connector on the Enterasys switch. (If there is a switch designated as the Manager, connect to its Console port.)
2.Plug the DB25 female connector at the other end of the cable into the port labeled COMM on the VT terminal.
3.Turn on the terminal and access the Setup Directory. Set the following parameters on your terminal:
Parameter | Setting | |
|
|
|
Mode | 7 | Bit Control |
|
| |
Transmit | Transmit=9600 | |
|
|
|
Bits Parity | 8 | Bits, No Parity |
|
|
|
Stop Bit | 1 | Stop Bit |
|
|
|
When these parameters are set, the Startup screen will display. Proceed to “Connecting to the Network” on page 3‐22.
