Related Documents
This preface provides an overview of this guide and the SecureStack C2 manual set, a brief summary of each chapter and defines the conventions used throughout this guide. To locate information concerning various subjects in this guide, refer to the following table:
For... | Refer to... |
|
|
An overview of the switch features and how to | Chapter 1, Introduction |
obtain technical support |
|
|
|
Network requirements that must be met before | Chapter 2, Network Requirements |
installing the switch |
|
|
|
Instructions to install the switch on a flat surface | Chapter 3, Hardware Installation |
or in a standard |
|
switch in a stacked configuration |
|
|
|
Troubleshooting installation problems and | Chapter 4, Troubleshooting |
diagnosing network/operational problems using |
|
the LANVIEW LEDs |
|
|
|
Specifications, environmental requirements, and | Appendix A, Specifications |
physical properties of the switch and optional |
|
XFPs |
|
|
|
Related Documents
The documents listed below provide the necessary information to install and configure the switch and can be obtained from the World Wide Web in Adobe Acrobat Portable Document Format (PDF) at the following site:
http://www.enterasys.com/support/manuals
•SecureStack C2 Installation Guide provides hardware specifications and instructions to install the switch and its options.
•SecureStack C2 Configuration Guide describes how to use the Command Line Interface (CLI) to set up and manage the C2 switch.
•SecureStack C2 Redundant Power System C2RPS‐SYS Installation Guide provides hardware specifications and instructions to install the power supply and its options.
•Cabling Guide provides information on dB loss and cable specifications.
Unlike the other documents listed above, the Cabling Guide is not listed alphabetically on the web site. Instead, it is listed under the Overview Guides link.
xvi About This Guide
