Using LANVIEW

Using LANVIEW

The switch supports the Enterasys Networks built‐in LANVIEW LED visual diagnostic and status monitoring system. The location of each C2K122‐24 LANVIEW LED is shown in Figure 4‐1. The LEDs enable you to quickly observe network status for diagnosing switch and network problems.

Figure 4-1 C2K122-24 LANVIEW LEDs

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Å

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Æ

 

 

 

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

16

17

18

19

20

21

22

23

24

25

 

26

 

 

 

1

 

 

 

 

 

 

 

 

 

 

11

13

 

 

 

 

 

 

 

 

 

 

23

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

MGR

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Console

 

RPS

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

25

 

26

 

 

UP

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CPU

DOWN

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

2

 

 

 

 

 

 

 

 

 

 

12

14

 

 

 

 

 

 

 

 

 

 

24

TX

RX

TX

RX

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

C2K122-24

 

 

1

Ã

 

 

MGR

 

 

Ä

 

 

RPS

À

 

UP

Â

 

2

Á

 

CPU

DOWN

 

 

 

 

1

CPU LED

6

Link/Activity LED for 10/100/1000 Mbps,

2

STACK DOWN LED

 

port 1 of the 24 RJ45 ports

3

STACK UP LED

7

Link/Activity LEDs for 10-Gbps XFP ports,

4

RPS LED for redundant power-source status

 

25 and 26

5Manager LED

Table 4‐2 describes the LED indications and provides recommended actions as appropriate.

Note: The terms flashing, blinking, and solid used in Table 4-2indicate the following:

Flashing: LED is flashing randomly.

Blinking: LED is flashing at a steady rate (approximately 50% on, 50% off).

Solid: LED is on steady and not pulsing.

4-2 Troubleshooting

Page 58
Image 58
Enterasys Networks manual Using Lanview, C2K122-24 Lanview LEDs