Enterasys Networks RBT-8200 manual Led

Front Panel Controls and Indicators

Table 1-2 LED Indicator Status

LED	Function
NIC1 activity	• A continuous green light indicates a link between the system and the network to which it
NIC2 activity	is connected.
	• A blinking green light indicates network activity.
Power/Sleep	• A continuous green light indicates that the system has power applied to it.
	• A blinking green light1 indicates that the system is sleeping.
	• No light indicates that the system does not have power applied to it (other than the 5 V
	standby power).
Hard drive	• A random blinking green light indicates hard drive activity (SCSI or IDE).
disk status	• A continuous amber light2 indicates a hard drive disk fault (SCSI or IDE).
	• No light3 indicates no hard drive activity or fault (SCSI or IDE).

System Status • A continuous green light indicates that the system is operating normally.

•A blinking green light indicates that the system is operating in a degraded condition.

•A continuous amber light4 indicates that the system is in a critical or nonrecoverable condition.

•A blinking amber light4 indicates that the system is in a noncritical condition.

•No light indicates POST/system stop.

Notes:

• The power LED sleep indication is maintained on standby by the chipset. If the system is powered down without going through BIOS, the LED state in effect at the time of power off will be restored when the system is powered on until the BIOS clears it. If the system is not powered down normally, it is possible that the power LED will be blinking at the same time that the system LED is off due to a failure or configuration change that prevents the BIOS from running.

•In order for a hard disk fault indication to occur, either an Intelligent Platform Manager Interface (IPMI)-based satellite management controller must send a Set Fault Indication command to the Baseboard Management Controller (BMC) or the system board must be used with the 1U SRT1300 hot-swappable backplane.

•The LED is also off when the system is powered off or in a sleep state.

•The amber status LED takes precedence over the green status LED. When the amber LED is on or blinking, the green LED is off.

RBT-8200 Wireless Switch Installation Guide 1-3