Enterasys Networks XSR-3020 CompactFlash Memory Card, LED Behavior, Figure A-28 XSR LEDs, State

Cable, CompactFlash and Accessory Specifications

CompactFlash Memory Card

The optional plug-in CompactFlash (CF) memory card, shown in Figure A-27, comprises a single chip controller and flash memory modules in a matchbook-sized package with a 50-pin, PCMCIA connector consisting of two rows of 25 female contacts each.

The PCMCIA male interface supports both Type I and Type II CF cards. Note that the CF release mechanism pops out when you install the card. For installation instruction, refer to “Hardware Installation” on page -1.

Figure A-27 CompactFlash Memory Card

Pin 1

Pin 50

Figure 1 CompactFlash Memory Card

LED Behavior

The 14 LEDs on the XSR front panel display system and port status as described in Table A-3. The six system LEDs are illustrated to the left and the eight GigabitEthernet LEDs to the right in Figure A-28. Note that Link and TX (transmit) green LEDs are provided for the GBIC port while each GigabitEthernet port has one green and one amber LED.

Figure A-28 XSR LEDs

NIM1NIM2

VPN

SYS

PWR

COM

	1000	10/100/1000
Link
TX	GBIC	ETH1

10/100/1000
ETH2	ETH3

	Table A-3 LED Description
LED	State	Function
NIM 1, NIM 2	ON	T1/E1, ISDN or HSSI card is present and power-up
		diagnostics test passed
	OFF	NIM slot empty or power-up diagnostics test failed
SYS(tem Status)	ON	XSR is operational
	OFF	Faulty hardware or Bootprom
	Blinking	Flash update is in progress (software image
		downloading), warning you not to power down the XSR.
		Powering down now can leave the branch router without
		valid software.

XSR Getting Started Guide A-21