Enterasys Networks XSR-3020 manual XSR Rebooting Characteristics, Initialization Output

XSR Rebooting Characteristics

XSR(config)#access-list 103 permit ip any 10.10.10.0 0.0.0.255

Create crypto map statements for each ACL entry with the more protective tunnel mode set by default. Match statements render associated ACLs bi-directional:

XSR(config)#crypto map test 101

XSR(config)#set transform-set ez-esp-3des-sha-pfs

XSR(config)#match address 101

XSR(config)#crypto map test 102

XSR(config)#set transform-set ez-esp-3des-sha-pfs

XSR(config)#match address 102

XSR(config)#crypto map test 103

XSR(config)#set transform-set ez-esp-3des-sha-pfs

XSR(config)#match address 103

Create the multi-point VPN virtual port required to terminate many clients:

XSR(config)#interface vpn1 multi-point

XSR(config)#description “VPN Virtual Interface Int0”

XSR(config)#ip address 10.10.10.1 255.255.255.0

XSR(config)#ip rip send version 2

XSR(config)#ip rip receive version 2

XSR(config)#ip multicast-redirect tunnel-endpoint

Enable RIP routing on all networks except the public interface:

XSR(config)#router rip

XSR(config)#network 172.16.10.0

XSR(config)#network 10.0.0.0

XSR(config)#passive-interface gigabitethernet2

XSR(config)#no receive-interface gigabitethernet2

XSR(config)#distribute-list 1 out vpn1

Finally, attach the crypto map statement to the public interface:

XSR(config)#interface gigabitethernet 2

XSR(config-if<G2>)#crypto map test

XSR(config-if<G2>)#end

XSR#copy running-config startup-config

XSR Rebooting Characteristics

When the XSR reboots, it conforms to the behavior described in this section. The output displayed at the CLI describes router initialization.

Initialization Output

The XSR displays the following output when it initializes (cold reboot):

The XSR displays the following output when it initializes (cold reboot):

X-Pedition Security Router Bootrom

Copyright 2003 Enterasys Networks Inc.

HW Version: 9002914-04 REV0A Serial Number: 3646031700233215

3-32 Software Configuration