Installation
DOOR INSTALLATION:
Please inspect all components for damage. If damage has occurred, please contact the courier company, dealer, or distributor and have components repaired or replaced before installation. Remove the door from the packaging. Inspect the door assembly for damage. 
1. Install door handle as shown in Figure 42.
Nut
Cast Latch
Washer (x2)
Spring Washer
Furel
Handle
Figure 43: Installation Door onto Unit.
Figure 42: Installation Door Handle
Hardware.
2.Place the door assembly on the two (2) hinge pins mounted on the body of the unit. Refer to Figure 43.
3.Open and close the door, applying pressure down, to ensure the door assembly is properly seated on the hinges. Refer to Figure 44.
4.Please clean all fingerprints off of all plated surfaces, with denatured alcohol on a soft cloth, before firing the unit each time. Fingerprints, etc., can become permanently etched into the plating if not removed before operating the stove.
NOTE: When the door is installed on the unit and the handle closed, ensure that the spring handle is at the 4:00 position.
Close the door |
assembly and |
turn the door |
handle |
downwards |
until door is |
tight. |
Thread slider |
damper handle |
onto slider damper |
control on the side |
of the unit. |
Figure 44: Closing Door.
DO NOT USE DOOR IF GLASS IS BROKEN.
35
