Installation
CERAMIC BAFFLE INSTALLATION:
1. Remove the front secondary air tube by placing a screwdriver (any style except flat head) into one of
the air holes and tapping it with a hammer/mallet to the left. Step 1 is only required on the insert models.
2.Slide the right ceramic baffle in over the secondary air tubes at the top of the firebox. The tab must be on the top and pointing towards the center and the smooth side is to face down.
3.Hook the outside edge of the baffle over the top of the secondary air chamber. This will make room to for the installation of the left ceramic baffle.
4.Slide the left ceramic baffle in over the secondary air tubes. The tab must be on the bottom and pointing towards the center and the smooth side is to face down.
5.Pull the baffles together in the middle so the right tab rests on top of the left tab. Ensure the baffles are flush with the back and both sides of the firebox.
FAN WIRING DIAGRAM:
Right Ceramic |
Baffle |
Left Ceramic |
Baffle |
Figure 45: Installation of Ceramic
Baffle.
This appliance, when installed, must be electrically connected and grounded in accordance with local codes or in the absence of local codes, with the current CSA C22.1 CANADIAN ELECTRICAL CODE. Part 1, SAFETY STANDARDS FOR ELECTRICAL INSTALLATIONS, or THE NATIONAL ELECTRICAL CODE ANSI / NFPA 70 in the USA.
CAUTION Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.
This is a basic wiring diagram for the option fan installation.
1)Plug the fan assembly into a three (3) prong (grounded) receptacle.
2)Turn the fan controller to the desired setting.
3)Once the unit has reached operating temperature, the fan temperature sensor will turn the fan on automatically.
4)When the unit cools down the fan temperature sensor will shut the fan off automatically.
����� | ��� |
|
|
| |
����� |
| ����� |
|
| |
| ����� |
|
��� |
|
|
����������� | ����� ������ |
|
������ | ��� | |
|
| ���������� |
DO oil the fan bearings regularly.
DO NOT cut or remove the grounding prong from the plug.
DO NOT route the power cord beneath the heater.
WARNING: This appliance is equipped with a
36
