Secondary Installation
CERAMIC BRICK LINER REMOVAL:
WARNING: DO NOT INSTALL LINER IF UNIT IS HOT.
1.Remove glass door (see MAINTENANCE AND SERVICE - GLASS DOOR REMOVAL)
2.Carefully remove the log set if it was installed.
3.Remove both side brick liners by sliding them out the front. Be careful not to scrape the liners on the
baffle tabs at the top.
4.Hold the back of the top liner up while lifting the back liner off the air deflector ledge then out. Slide the top liner out from the lip on the baffle then remove it from the unit.
5.If the baffle needs to be removed use a
To install the liners follow steps 1 to 5 in reverse.
Important installation notes:
Ensuring the side brick liners are behind the baffle tabs and are flush against the firebox walls.
When sliding the baffle into place making sure to hook the back into place on the two loosened screws.
To install the log set follow the instruction in LOG
SET AND EMBER INSTALLATION.
LOG SET AND EMBER INSTALLATION:
Top Brick Liner | Baffle Lip | |
Baffle Tab | ||
|
| Back Brick Liner |
Leftt Side |
|
Brick Liner | Right Side Brick Liner |
| |
| Air Deflector Ledge |
For clarity unit is not shown.
Figure 33: Cast Iron Brick Liner Installation.
The placement of the logs is not arbitrary. If they are positioned incorrectly, the flames can be “pinched” and will not burn correctly. The burner (Figure 34) and a few of the logs come with locator pins, notches, and ledges which make alignment easier. The andirons and grate must be installed for the logs to be placed properly. Using the pictures provided, carefully set the logs in place (see Figures 35 through 41).
NOTE: The logs are fragile and should be handled gently.
Maintenance: Once a year the logs should be removed and checked for deterioration or large amounts of soot. A small amount on the bottom side of the
logs is normal. Remove and replace the logs in the same manner described in this section.
If new/more embers and rock wool is required, contact your nearest ENVIRO dealer.
Never operate the fireplace with the glass door removed.
Figure 34: This is how the fire box looks with only the andirons and grate in place. This points out the three ledges at the back and three locator pins on the burner.
Figure 34. Placement of ledges and pegs in empty
firebox.
26
