Enviro EF-119 owner manual Installation, Exhaust, Freestanding, Fireplace Insert, Built-In Heater

Installation

OUTSIDE FRESH-AIR CONNECTION:

Outside fresh air is mandatory when installing this unit in airtight homes and mobile homes.

When connecting to an outside fresh air source, do not use plastic or combustible pipe. A 15⁄8” minimum (42 mm) ID (inside diameter) steel, aluminum or copper pipe should be used. It is recommended, when you are installing a fresh air system, to keep the number of bends in the pipe to a minimum.

�������

����

����� ��

��� ���

��������

�����

Figure 16: Outside Air Connection.

EXHAUST AND FRESH AIR INTAKE LOCATIONS:

EXHAUST	Freestanding		Fireplace Insert		Built-In Heater
Base of unit to center of flue	16 3⁄8”	(41.5 cm)	9”	(22.8 cm)	10 3⁄4”	(27.3 cm)
Center of unit to center of flue	5 3⁄4”	(14.6 cm)	5 3⁄4”	(14.6 cm)	5 3⁄4”	(14.6 cm)
FRESH AIR INTAKE.
Base of unit to center of intake	10 3⁄4”	(27.3 cm)	3 3⁄8”	(7.4 cm)	5 1⁄8”	(8.6 cm)
Center of unit to center of intake	1”	(2.5 cm)	1”	(2.5 cm)	1”	(2.5 cm)

��	� ����
��� ���	���� ���
�� ����	�� ����
	���� ���
���� ���

Figure 17: EF2 Freestanding Inlet and Outlet Location.

INSTALL VENT AT CLEARANCES SPECIFIED BY THE

VENTING MANUFACTURER

��	� ����
��� ���	���� ���
��� � ����
��� ���	��� ��
��� � ����
	���� ���
���� ���
	��� �� ����
	���� ���

Figure 18: EF2 Fireplace Insert Inlet and Outlet Location.

16