Enviro EF-119 Installation, stove, Wall, thimble, 30.5 cm, elbow, Existing floor, combustible

Installation

HORIZONTAL EXHAUST THROUGH WALL INSTALLATION - FREESTANDING:

Vent installation: install vent at clearances specified by the vent manufacturer.

A chimney connector shall not pass through an attic or roof space, closet or similar concealed spaces, or a floor, or ceiling. Where passage through a wall or partition of combustible construction is desired, the installation shall conform to CAN/CSA-B365 Installation Code for Solid-Fuel-Burning Appliances and Equipment. Only use venting of L or PL type with an inside diameter of 3 or 4 inches (7.6 or 10.1 cm).

1.	Choose a location for your stove that meets the requirements stated in this manual and allows
	installation with the least amount of interference to house framing, plumbing, wiring, etc.
2.	Install a non-combustible hearth pad (where necessary).
3. Place the appliance 15” (37.5 cm)											Wall
	away from the wall. If the stove is
	to be set on a hearth pad, set the									2"	thimble
	unit on it.									(5 cm)	12"
4.	Locate the center of the exhaust										(30.5 cm)
	pipe on the stove. Extend that line										45°
	to the wall. Once you have located
											elbow
	the center point on the wall, refer to
	pellet vent manufacturer installation
	instructions for correct hole size and								6"
	clearance to combustibles.										Rodent
5.	Install the wall thimble as per the								(15 cm)		mesh cap
	instructions written on the thimble.										Fresh air
	Maintain an effective vapour barrier										intake
	in accordance with local building
	codes.								Non-combustible	Existing floor
6.	Install a length of 3” (76 mm) or
									floor protection.	(combustible)
	4” (101 mm) vent pipe into the
	wall thimble. The pipe should								Figure 21: Straight through wall Installation.
	install		easily			into	the
	thimble.
7.	Install		the		fresh		air
	intake		(see			OUTSIDE
	FRESH AIR CONNECTION).
8.	Connect			the		exhaust				Exhaust Tube
	vent		pipe			to	the			3" (75mm) or 4" (100mm) "PL" or "L" vent
	exhaust				pipe		on
	the	stove.			Seal		the			Wall Thimble
	connection				with		high
	temperature silicone.
9.	Push the stove straight										45° Elbow with screen or
	back,			leaving			a
											Termination Cap
	minimum of 2” (5 cm)
	clearance				from		the
	back of the stove to							Fresh Air Intake
	the wall. Seal the vent
	pipe		to	the		thimble			High Temperature RTV
									Silicone Required
	with high temperature							Figure 22: Venting to use with straight through wall Installation.
	silicone.

18