Enviro EF-119 owner manual Installation, This unit includes a 3” 75 mm pedestal

		Installation
INSTALLATION FOR A BUILT-IN HEATER:
Combustible			This unit includes a 3” (75 mm) pedestal
			and surrounding faceplates. The part of the
materials and
structure			unit behind the faceplate can be enclosed
			with combustible material. It has 1” (25
Surround Panel		Wall	mm) standoffs to establish clearances to
		thimble	combustibles to the back, top and sides.
		12"	Refer to “CLEARANCES TO COMBUSTIBLES - BUILT-IN
		(30.5 cm)
		45°	HEATER“ and Figure 6 and 7 for the size and
			placement of the alcove to be built for the
		elbow
			unit.
6"		Rodent	For the venting refer to “HORIZONTAL EXHAUST
(15 cm)		mesh cap	THROUGH WALL INSTALLATION - FREESTANDING“.
		Fresh air
		intake
Non-combustible		Existing floor
		(combustible)
floor protection.	3" (7.5 cm)
	Pedestal

Figure 30: Built-in heater installation.

INSTALLATION OF CONTROL PANEL INTO SURROUND PANEL - FPI AND BIH:

When installing the control panel into the surround panel, the surround does not need to be assembled. The control board will be found in behind the firebox.

Place the control panel on the backside of the right surround panel so the hinge is on the outside and the top and bottom holes on the control panel line up with those on the surround. Attach using two

(2) T-20 screws through the front of the surround into the circuit board control panel.

After the surround has been assembled and is ready to be installed on the unit, plug the wiring harness into the control panel (see Figure 32).

Figure 31: Control Panel Cover.

����

Figure 32: Control Panel Back

- Timer.

24