Enviro EG 28 B owner manual Parts And Accessories

PARTS AND ACCESSORIES

Service Parts available from your local Envirogas Dealer

Burner Control Assembly	Convection Blower
Natural Gas Pilot Assembly	Light Bulb Holder
Propane Pilot Assembly	Light Switch (momentary)
Door Bolt	Fan Controller
Relief Door Gasket	Log Set (with Embers)
Regulating Valve	Thermocouple
Piezo Igniter	Embers
Burner Switch	Thermopile
B-vent Spill switch 220°	Door Gasket
Orifice Blank	Convection Fan Sensor 120° (48°C)

Accessories

Gold trim Package

Low Voltage Thermostat

REMOVING or INSTALLATION OF THE BLOWER

1. Turn the unit off and remove the log set.

2.Remove the burner tray assembly by removing the screw on either side of the tray, between the front and rear burners. Lift the tray out

3.Remove the 4-5/16” bolts that hold the blower mounting plate to the back firewall. Use a light lubricating oil on screws before removal.

4.Carefully pull the assembly into the firebox.

Install the blower onto the mounting bracket (blower outlets pointing through the two holes in the bracket) using the 4 screws provided.

5.Connect wires according to the wiring diagram. (If removing the blower, disconnect the blower leads from the harness. Remove the blower.)

6.Check mounting plate gasket and reverse

steps 1 through 4.

14