INSTALLATION
BRICK PANELS INSTALLATION
1)Unhook the 2 spring loaded hooks from the bottom of the fl ush door and lift the Flush Front off the unit.
2)Unwrap the brick pattern panels from the protective wrapping.
Note: The logs must not be in the unit.
a)Loosen the two screws from the bottom of the baffle plate. Install the bottom clips onto the baffle plate (refer to Diagram 1).
5)Place the top bracket onto the front edge of the top panel (refer to Diagram 5).
Top Bracket
Diagram 5
6) Slide the top panel and bracket assembly carefully onto the baffle plate ensuring the panel is centered. Make sure the tabs of the top bracket fi t into the baffle openings (refer to Diagrams 6 & 7). The back of the top brick panel sits on top of the bottom clips.
Tabs
Diagram 1 |
|
3) Insert the back brick panel fi rst by carefully slipping it between the | Diagram 6 |
back wall of the fi rebox and the rear log bracket (refer to Diagram 2). |
|
Diagram 2 |
|
|
|
4) Put the side panels in next. Tilt them in towards the middle of the |
| Diagram 7 | |
|
|
| |
fi rebox and put the bottom front corner in fi rst. Be very careful not | NOTE: If the bottom brick panel must be removed: Remove the | ||
to scratch them on the fi rebox hardware. Place them fl at up against | grate, then remove the Burner Tray. See "Removing | ||
the wall, they should fi t snugly against the top of the fi rebox (refer to | Valve" section. | ||
Diagrams 3 & 4). |
|
|
|
|
|
| |
|
| IMPORTANT |
|
|
| Dangerousoperatingconditionsmay |
|
|
| occur if the panels are broken. |
|
Diagrams 3 & 4
30 | Regency® |