|
|
| INSTALLATION |
UNIT ASSEMBLY | TOP FACING SUPPORT AND | "C" Screw Position: | |
PRIOR TO | SIDE NAILING STRIPS | For a facing material depth of | |
|
| ||
Determine the total thickness of facing material | the top facing support must be reversed. | ||
INSTALLATION |
| ||
(e.g. drywall | plus ceramic tiles) to allow the |
| |
The Top Facing Support, the Side Nailing Strips | fi nished surface to be fl ush with the front of the |
| |
unit. Total facing thickness can vary from 1/2" |
| ||
and the 2 Top Standoffs must be correctly | (13mm) to |
| |
positioned and attached to the top before unit |
|
|
|
is slipped into position. | TheTopFacingSupport&SideNailingStripscan |
| |
TOP STANDOFF ASSEMBLY | be mounted in 3 different positions depending |
| |
on the thickness of the facing material. |
| ||
The top standoffs are shipped in a fl at position |
|
|
|
and must be folded into shape and attached. |
|
|
|
1) Remove the standoffs from the fi replace | Screw | Facing Material Depth |
|
Position |
|
| |
top. |
|
| |
A | 1/2" / 13mm |
| |
|
|
2) Take each standoff and bend into the correct | B | 7/8" / 22mm |
| ||
shape. Bend up at the bend lines until the |
| ||||
C* | 2) Use the same screw hole position for the | ||||
screw holes in the standoff and the pre- | |||||
punched screw holes on the fi replace | top |
|
| Side Nailing Strips as was used for the Top | |
line up. | * For "C" screw position the top facing support | Facing Support. Attach each side nailing | |||
is reversed. |
| strip using 3 screws. | |||
|
| ||||
3) Attach the standoff securely to the | top |
|
|
| |
with 2 screws per standoff (on opposite |
|
|
| ||
corners). | 1) | Mount Top Facing | Support using the 3 |
| |
|
| ||||
|
| supplied screws into the three |
| ||
|
| screw holes on the top front of the unit. Use | VENTING | ||
|
| hole positions A, B, or C depending on your | |||
|
| facing depth. |
| INTRODUCTION | |
|
|
|
| ||
|
|
|
| The | |
|
|
|
| Co Axial system. The inner liner vents products | |
|
|
|
| of combustion to the outside while the outer | |
|
|
|
| liner draws outside combustion air into the | |
|
|
|
| combustion chamber thereby eliminating the | |
|
|
|
| need to use heated room air for combustion and | |
|
|
|
| losing warm room air up the chimney. | |
|
|
|
| Note: These flue pipes must not be | |
|
|
|
| connected to any other appliance. | |
|
|
|
| The gas appliance and vent system must be | |
|
|
|
| vented directly to the outside of the building, | |
|
|
|
| and never be attached to a chimney serving a | |
|
|
|
| separate solid fuel or gas burning appliance. | |
|
|
|
| Each direct vent gas appliance must use it's own | |
|
|
|
| separate vent system. Common vent systems | |
|
|
|
| are prohibited. |
Regency® | 11 |