EPoX Computer EP-6VBA Installation, Device Connectors continued, J3 + +, Power On/Off

Installation EP-6VBA

Device Connectors (continued)

J3

+

+

(This is connected to the power button on the case. Using the Soft-Off by Pwr-BTTN feature, you can choose either Instant Off (turns system off immediatly), or 4 sec delay (you need to hold the button down for 4 seconds before the system turns off). When the system is in 4 sec delay mode, there is a special feature to make the system to go into suspend mode when the button is pressed momentarily.)

Power On/Off
1
Turbo LED indicator - LED ON when higher speed is selected
IDE LED indicator - LED ON when Onboard PCI IDE Hard
disks is activate
IR Connector
1. VCC	4. GND
2. NC	5. IRTX
3. IRRX
1

J2

Power LED - Power LED connector

1. Power LED(+)	4. NC
2. N/C	5. GND
3. GND
1
Speaker - Connect to the system's speaker for beeping
1. Speaker	3. GND
2. N/C	4. GND
1

Reset - Closed to restart system.

1

Page 3-10