note

You can also use the remote control’s Auto button to automatically reset the projector’s tracking, sync, resolution, and position settings. See page 25 for details.

5.Use the pointer button to adjust the hue and saturation. You see the adjustments reflected on the screen. When you are satisfied

with the color, press Esc.6.Repeat steps 4 and 5 for each color axis you want to adjust.

You may need to readjust the color as the lamp in your projector changes over time.

Adjusting Signal Settings

Although the projector normally detects and optimizes the input signal automatically, you can use the Signal menu to make manual adjustments. In addition to changing the position of the projected image, you can correct tracking and sync for computer images, or change the aspect ratio to widescreen format for video images.

1.Press the Menu button and select the Signal menu.

You see a screen similar to one of those below. (The settings will be different depending on the source you are projecting from.)

Computer image

Component video

Composite video/S-video

2.Use the pointer button to highlight the desired option, then adjust it as needed:

■Auto Setup

Leave this setting on to automatically optimize the image when Computer is selected as the source. Turn it off if you want to save adjustments you have made to the video settings.

■Resolution

When set to Auto, the resolution (size) of a computer image is automatically detected so it can be scaled to fit in the

54Fine-Tuning the Projector