Epson 31-396 instruction manual Removing the Drum

REMOVING THE DRUM

DISCONNECT MACHINE FROM POWER SOURCE.

1.Open the belt sander guards and remove the sanding belt.

2.Remove nut (A) and washer from the shaft (J) Fig. 59.

3.Insert the two 1/4-20x1-3/4" socket head screws through holes (C) and (D) Fig. 60, on the retraction plate

(E).

4.Thread screws (C) and (D) Fig. 60 into the two tapped holes (F) in the drum.

5.Thread a 5/16-18 x 1-1/4" socket head screw (G) Fig. 61, into the tapped hole (H) in the retraction plate.

6.Turn screw (G) Fig. 61, against shaft (J) Fig. 60. This will pull the drum off the shaft.

7.To install drum, place the drum on the shaft, replace the washer and nut that were removed in STEP 2 and tighten securely.

A

J

Fig. 59

F

J

C

E D

Fig. 60

H

G

Fig. 61

22