Epson 31-396 instruction manual

7.Thread the ratchet handle (J) Fig. 24, into the tapped hole (K) and tighten securely.

NOTE: ratchet handle (J) is spring loaded and can be repositioned by pulling out on the lever and repositioning it on the serrated nut located underneath the lever.

8.Place one of the three rubber sanding drums and sand paper (L) Fig. 25 on the sanding spindle.

9.Place the 5/16" spindle washer (M) Fig. 26, on a 5/16-18x1/2" hex head screw (N). Thread screw into tapped hole on end of sanding spindle. Place the rod (P) into the hole on the side of the spindle to lock the spindle. Tighten screw securely with the 12mm open end wrench.

10.Remove the three flat head screws (O) Fig. 27, that hold the table insert (P) to the sanding table.

11.Remove the 4" table insert (R) Fig. 27, and replace it with the appropriate table insert.

1-1/2" Drum	-	1-1/2" Table Insert
2" Drum	-	2" Table Insert
3" Drum	-	3" Table Insert

(See Fig. 5)

K

J

Fig. 24

L

Fig. 25

M

N

P

Fig. 26

O P

O

O

Fig. 27

13