2-20 Using EPSON Photo!3
LProof Sign-off:
K. Pipa _______
M. Fujimori _______
R. Thomson _______
R4C5700
Rev. C
A5 size PHT3.FM
4/6/01 Pass 0
Changing computer connection settings
You can change the way that your computer and
camera communicate using the Port and Speed
settings. You can also test the connection and establish
communication by clicking the Test Connection
button. Connection information appears in the
Computer Connection window.
Note:
❏Make sure that the camera’s dial switch is set to
(for PhotoPC 3000Z), or (for PhotoPC 850Z and
800).
❏Do not change the Port and Speed settings from Auto
unless you know the configuration of the serial port
that you want to use. If you change the Port and Speed
settings, you may lose the connection between the
camera and your computer.

Changing the communication port

You can change the communication port that is used
to connect the camera to your computer. When Auto
is selected on the Setup menu, EPSON Photo!3 selects
the port automatically. If you wish to specify the port
yourself, refer to the appropriate section below for
your operating system.

For Windows

Depending upon the type of cable that you are using
to connect your camera to your computer, you can
select Auto, USB, or any available COM port, from
COM1 to COM9.

For Macintosh

Depending upon the type of cable that you are using
to connect your camera to your computer, you can
select Auto, USB, Modem Port, or Printer Port.

Changing the serial communication speed

You can change the speed at which EPSON Photo!3
communicates with the camera. When Auto is
selected on the Setup menu, EPSON Photo!3
automatically selects the fastest possible
communication speed. The following speed settings
are available:
Auto, 19200, 38400, 57600, 115200, and 230400 bps.