Settings 1 to 9 have priority over the software designation. Software selection will be ignored after setting this switch to 1~ 9. If the switch selection is altered during prin- ting, it will become effective after the current print command is executed.

8.RESET Switch

When this switch is pressed, the printer enters the reset state. When released, the initialization operation is performed once again, This puts the printer in the same condition as at power-on.

9.POWER Lamp (Green)Lights up when power is on. Blinks if an error has been generated.10. ON-LINE Lamp (Green)

Data can be input when the printer is the ON-LINE state. The ON-LINE lamp is lit when the printer is ON-LINE, off when the printer is OFF-LINE. When the printer is OFF- LINE, a BUSY signal is output by the printer.

11. P. EMPTY Lamp (Red)

When a paper-empty signal is detected, the P.E. indicator lights and the buzzer sounds for 3 seconds. At this time, the printer goes OFF-LINE, and the BUSY and P. EMP signals are output. If paper-empty is detected during printing, operation is terminated at completion of the line in which the signal is received.

If the ON-LINE switch is pressed after paper is inserted, the P. EMP state is terminated. If the ON-LINE switch is pressed without new paper inserted, a single line is printed (during printing the ON-LINE lamp is lit) and the OFF-LINE state is entered again. This operation can be repeated as many times as desired.

5