CONTROL CODE EXPLANATION

Print Commands

1. (0D)H (13)D, (8D)H (141)D

Input of this code initiates printing. DIP SW2-2 indicates whether or not a line-feed is to be performed after printing. When no print data is input, the printhead does not move. Print data input after this print command has been performed is printed at the beginning of the line.

If a line-feed is to be performed and if the command (double-width character mode) is set, that mode is deleted.

2. (0A)H (10)D, (8A)H (138)D

Input of this code results in printing and line-feed. The line-feed width is set by the line-feed amount command. If no print data has been input, only a line-feed is per- formed. By setting DIP SW2-1, it is possible to have the data print out start at the beginning of the next line.

This command terminates the double-width character mode set by the command.3. (0C)H (12)D, (8C)H (140)D

Input of this code results in line-feeds after printing until the top of the next page is reached. The setting for one page is performed by the switch located at the front of the printer or by the software designation.

Print data following the command is printed at the beginning of the line.
The double-width character mode set by the

command is terminated.

4. (0B)H (11)D, (8B)H (139)D

Input of this code results in a paperfeed until the next vertical tab. If a vertical tab is not set, this command performs the same operation as the code. If at least one vertical tab is set and there is no setting until the next page, a paper-feed is carried out until the top of the next page is reached.

If the(double-width character mode) is set, it is terminated.

 

Setting of a vertical tab is performed by theo r

 

command.
5. (1 B, 4A, n)H (27, 74, n)D, (9B, CA, n)H (155, 202, n)D

0 [ n [ 255.n is a binary 8-bit code. Input of this code results in a n/180 inch paper- feed after printing. This line-feed value is not stored within the printer. This starting position of the next line is at the right side of the line printed previously.

When n IS not 0, the mode is canceled if it is set.

38