Using the Projector on a Network 97
Using SNMP to Monitor the Projector
Network administrators can use SNMP (Simple Network
Management Protocol) to monitor projectors.
1. Press the Menu button on the remote control, select the
Network menu, then press Enter.
2. Choose Network Configuration and press Enter.
3. Choose Others, then press Enter. You see the following screen:
4. Turn on the SNMP setting.
5. Enter up to two IP addresses for notification in the Trap IP
Address fields.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used: 127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
To enter numbers, use the arrow buttons on the remote control to
select each number on the screen, then press the Enter button.
When you’re finished entering an address in the network menu,
highlight Finish, then press the Enter button.
6. For Priority Gateway, select Wired or Wireless. Press Esc to
return to the previous screen.
note
If you’re a network
administrator, you can use
the SNMP option to enter a
trap IP a ddr ess . Th is l ets yo u
receive trap alerts for the
projectors you’re monitoring.