a.Connect the small end of the main cable to the projector’s Mouse/Com 1 port. (Use the Mouse/Com 2 port if you are connecting a second computer.)
b.Connect one end of the PS/2 mouse cable included with the projector to the mouse terminal on the square end of the main cable.
c.Disconnect the computer’s PS/2 mouse cable from the mouse port on the back of your computer and replace it with the other end of the mouse PS/2 mouse cable included with the projector.
d.If your system uses a serial mouse, perform steps b and c using the serial mouse cable instead of the PS/2 mouse cable (not shown in the illustration).
e.To configure the projector from your PC using the
ELP Link II software or to use the Effects buttons on the remote control, connect one end of the serial cable to the serial terminal on the square end of the main cable.
f.Connect the other end of the serial cable to the serial port on the back of your computer.
Note: You will not be able to use ELP Link II software if your system has only one serial port that is being used to support a serial mouse.
g.Tighten the screws on all connectors to make sure they are fas- tened securely.
10 | 1 • Installation |