Configuring the Print Server

After your print server is set up and plugged in, you’re ready to configure it for your network.

1. On the Wireless Server Search screen click START.

WP-Admin picks up the signal from the print server and displays information like the following:

This information

This number

appears when the

server is found

Note:

indicates the signal strength

If WP-Admin fails to pick up a signal from the print server, try holding down the print server’s test button for at least five seconds to reset it. The lights go out, then both the green and yellow lights come on briefly. The yellow light remains on when your network has a connection to the print server.

If it still fails to pick up a signal, check the solutions beginning on page 45.

If WP-Admin picks up a signal from more than one print server, select the connection that matches the MAC address on the back of your print server.

2.Check the signal strength to make sure you have a strong link to the print server.

When you have a link, click STOP, then click

CONFIGURE.

You see the password

Click OK

window:

 

24Installing and Configuring the Software for Windows