Epson C I - 4 0 8 0, C I - 4 0 7 0 user manual Standard Configuration, For the CI

Configuring the printer

3.2Standard Configuration

The standard configuration is reflected in the following printout provided that no parameters have been changed.

Sfor the CI - 4070

PRINT OUT		VERSION		208xxxxx
INTERFACE		ADJUSTMENT
BUFFER	8 KBYTE	AGC POSITION		24
WORD LENGTH	8 BIT	PLATEN GAP		0
I/F TYPE	SHARED	PAPER-IN ADJ.		0	*)
BAUD-RATE	9600 BPS	CUT. V-POS LO.		0
PARITY BIT	IGNORE	CUT. V-POS UP.		0
PROTOCOL	DTR	UNI-DIRECT.CMD		YES
		TRACT. FF-MODE		IGNORE FF
		MENU ACCESS		ALL FUNCTIONS
CURRENT SETTINGS		MACRO 1*	12	MACRO 3	MACRO 4
FONT	DATA	DATA	DATA	DATA	DATA
PRINT QUALITY	LQ	LQ	LQ	LQ	LQ
GRAPHICS QUAL.	STANDARD	STANDARD	STANDARD	STANDARD	STANDARD
SUB/SUPER FONT	YES	NO	YES	YES	YES
PITCH	10 CPI	10 CPI	10 CPI	10 CPI	10 CPI
LINE	6 LPI	6 LPI	6 LPI	6 LPI	6 LPI
PAGE LENGTH	72 LINES	72 LINES	72 LINES	72 LINES	72 LINES
TRACT.L. V-POS	0	0	0	0	0
TRACT.U. V-POS	0	0	0	0	0
LEFT MARGIN	1 COLUMNS	1 COLUMNS	1 COLUMNS	1 COLUMNS	1 COLUMNS
RIGHT MARGIN	136 COLUMNS	136 COLUMNS	136 COLUMNS	136 COLUMNS	136 COLUMNS
TOP MARGIN	1 LINES	1 LINES	1 LINES	1 LINES	1 LINES
BOTTOM MARGIN	1 LINES	1 LINES	1 LINES	1 LINES	1 LINES
PERF. SKIP	YES	YES	YES	YES	YES
PAPER SOURCE	TRACTOR LOWER	TRACTOR LOWER	TRACTOR LOWER	TRACTOR LOWER	TRACTOR LOWER
EMULATION	EPSON LQ	EPSON LQ	IBM PROPR.	IBM PROPR. AGM	EPSON LQ
CHARACTER SET	EPSON EXT. GCT	EPSON EXT. GCT	IBM SET 2	IBM SET 2	EPSON EXT. GCT
	3: GERMANY	3: GERMANY	1: U.S.A.	1: U.S.A.	1: U.S.A.
LINE MODE	LF=LF, CR=CR	LF=LF, CR=CR	LF=LF, CR=CR	LF=LF, CR=CR	LF=LF, CR=CR
$$-COMMAND	NO	NO	NO	NO	NO
TEAR-OFF / CUT	NO	NO	NO	NO	NO

Note: An asterisk (’) after MACRO 1 indicates the actual macro.

*) This value is dependent on factory setting!

All this standard settings of the firmware will be restored with the menu function RECALL FACTORY.

3-3