Configuring the printer
SPaper Exit (only for CI - 4080)
It is possible to choose between BATCH (to leave the printer at the rear) and STACKER (at the top) via the point PATH.
If BATCH is selected, the paper keeps its continuous form and leaves the printer at the rear. The cutter is not activated by default. If print jobs need to be separated, the cutter must be activated.
If STACKER is selected the fanfold paper automatically leaves the printer as cut sheets which are collected face down in the stacker at the top. The paper is cut along the perforation as long as no other form length has been defined. The form length can be determined in the menu or by the application. Printing briefly stops when the paper arrives at the cut station. The paper gets cut and is transported to the stacker. Afterwards, printing resumes.
Note: If, for some reason, it is not desired to print exactly on the perforation it is very important to cut below the perforation of the printed page. If the paper is cut above the perforation the remaining paper can easily bend and cause a paper jam. Do not cut through a label as the blad would get dirty by the glue.
SSTACK.CAPACITY (capacity at the top) (only for the CI - 4080)
SBATCH CAPACITY (capacity of the option at Cut Sheet Tray at the rear) (only for the CI - 4080)
To control the capacity of the Stacker or the Cut Sheet Tray use these two functions. Capacity can be defined in steps of 20 single sheets.
S STACK.CAPACITY in the range from 20 to 200 and
S BATCH CAPACITY from 20 to 600 sheets. (single sheet paper, see chapter 6 Technical Data, paper specification )
Change of Paper Exit (only for the CI - 4080)
When switching from one paper exit to the other, paper in the printer moves automatically to the cut station where it is cut at the perforation below the last printed page.
